dimensions: The front panel of the 1066 measures 45mm x 220mm (1.75" x 8.70")power requirements 24 volts D.C. at approximately 100 mA.
connections:
A input 0 degrees L external fader output
B input 180 degrees } mic M
C N } switch (when fitted)
D P unbalanced Output
E 24 volts- R output 0 degrees
F input 0 degrees S output center - tap
H input 180 degrees } line T output 180 degrees
J U 24 volts+
K external fader input V chassis
mic sensitivity in 5db steps range between -80 and-20
line sensitivity also in 5db steps range -20 to +10
treble control is continuously variable at 10kHz
mid Range Frequencies are continuously variable: 0.7, 1.2, 2.4, 3.6, 7.0 kHz
bass Frequencies are continuously variable:35, 60, 100, 220 Hz
high pass filter Frequencies range 45, 70, 160, 360
the EQ is switchable; in/out and there is a phase switch
notes:
The negative side of H.T. supply is amplifier "common signal" rail and should be connected to point 'V' (module case) at one point only in the system. When a
number of modules are used together, 'V' should be connected to the frame or desk in which they are mounted and the frame itself connected to one side of the supply at one point only.
